Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Reducing Bolt Diameter
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="DSheetz" data-source="post: 1756512" data-attributes="member: 91783"><p>Yes you can if you take your time and set it up dial it in good in a four jaw chuck . I myself would use a cobalt tool instead of a carbide tool set at just one or two thousands below center and your lathe is tight without a lot of slack in the gibs or half nuts .</p></blockquote><p></p>
[QUOTE="DSheetz, post: 1756512, member: 91783"] Yes you can if you take your time and set it up dial it in good in a four jaw chuck . I myself would use a cobalt tool instead of a carbide tool set at just one or two thousands below center and your lathe is tight without a lot of slack in the gibs or half nuts . [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Reducing Bolt Diameter
Top