Redding FL type s bushing die in 7mm rem mag. .301” bushing

[GW Hunter]

Can't find these anywhere. Need for a buddy....

 

[JJMoody]

You sure on that bushing size? That'd be a pretty darn tight chamber.

 

[codyadams]

That is tight for standard brass...normally you run around .308-.312. This doesn't apply if your neck turning your brass to about .0105" or so....

 

[GW Hunter]

PPU brass .010"....

 

[JJMoody]

Wow ... 10-4 will look around.

 

[LaHunter]

That's sounds pretty thin walled. My 7 mag loaded rounds measure .3135" diameter at the ends of the neck, just rear of the chamfer. I just ordered a Redding FL Bushing die & bushings sized at .310", .311", & .312". I am using new / FL sized Norma brass. Are you measuring a loaded round to determine the bushing size or actually measuring wall thickness?

 

[GW Hunter]

Ball mic to measure wall...

 

[codyadams]

PPU brass .010"....

I'll keep my eyes open, I am looking for a .311 or .312 bushing for a Redding 28 nosler die, I'll expand my search for the same 7 rem mag die/bushing too. I'm also loading for a buddy.....strange how that works ha ha.

 

[GW Hunter]

I'll keep my eyes open, I am looking for a .311 or .312 bushing for a Redding 28 nosler die, I'll expand my search for the same 7 rem mag die/bushing too. I'm also loading for a buddy.....strange how that works ha ha.

they'd be helpless without me...

 

[codyadams]

they'd be helpless without me...

Know how that goes ha ha