Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Recommendations for thread and blended protector?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="tobnpr" data-source="post: 3055378" data-attributes="member: 68758"><p>Thread protectors are easy peasy, simple to machine them as needed. I just grab a piece of round stock slightly larger than the muzzle OD, chuck it up, turn it down to the muzzle OD, drill/tap, knurl it, part it off then Cerakote or cold blue to match the barrel. Smith should be able to thread them without pulling the barrel unless you've got any "short" barrels. Gonna depend on his lathe, I've got to pull barrels shorter than 20".</p></blockquote><p></p>
[QUOTE="tobnpr, post: 3055378, member: 68758"] Thread protectors are easy peasy, simple to machine them as needed. I just grab a piece of round stock slightly larger than the muzzle OD, chuck it up, turn it down to the muzzle OD, drill/tap, knurl it, part it off then Cerakote or cold blue to match the barrel. Smith should be able to thread them without pulling the barrel unless you've got any "short" barrels. Gonna depend on his lathe, I've got to pull barrels shorter than 20". [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Recommendations for thread and blended protector?
Top