Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Recoil Bedding; Attempt on HMR
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Dean2" data-source="post: 2708412" data-attributes="member: 26077"><p>Both Devcon and JB melt very easily. Devon starts to get soft at 225 F and VERY soft at 250 F. Since 212 F is the boiling point of water that isn't all that hot in my books. I have used the same method to remove JB Steel, but I don't know the exact melt point of it, it didn't seem to take as much heat as the Devcon needed.</p></blockquote><p></p>
[QUOTE="Dean2, post: 2708412, member: 26077"] Both Devcon and JB melt very easily. Devon starts to get soft at 225 F and VERY soft at 250 F. Since 212 F is the boiling point of water that isn't all that hot in my books. I have used the same method to remove JB Steel, but I don't know the exact melt point of it, it didn't seem to take as much heat as the Devcon needed. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Recoil Bedding; Attempt on HMR
Top