Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Reamer/reloading question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ImBillT" data-source="post: 3052532" data-attributes="member: 117715"><p>How much clearance depends on what you want. Benchrest shooters turning necks after goin around .0005" per side or .001" total clearance. Thats a bit tight for unturned necks as only slight variation from the factory could cause an unsafe condition. Many "no turn" match chambers are roughly .002" total clearance, but are designed for specific brass and you can't change brands without carefully checking. Plenty of factory chambers have more clearance than what you're showing.</p></blockquote><p></p>
[QUOTE="ImBillT, post: 3052532, member: 117715"] How much clearance depends on what you want. Benchrest shooters turning necks after goin around .0005” per side or .001” total clearance. Thats a bit tight for unturned necks as only slight variation from the factory could cause an unsafe condition. Many “no turn” match chambers are roughly .002” total clearance, but are designed for specific brass and you can’t change brands without carefully checking. Plenty of factory chambers have more clearance than what you’re showing. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Reamer/reloading question
Top