Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
pulled bullet questions???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="djtjr" data-source="post: 402913" data-attributes="member: 13195"><p>ok i loaded a bunch of bullets to do a ladder test for a gun that i just finished breaking in and going to my car i dropped the bullets and they sacttered :'( anyway i obviously have to start over so i pulled the bullets and began from scratch. i had to use a 6mm sinclair puller the plier type and they were 6.5mm bullets but it seemed to work. as i re seated the bullets i noticed my seating dei was scaring the edges of most of these previously pulled bullets but not new ones. so it seams the pulling or clamping of the bullet took them out of round slightly and i confirmed this with a mic. </p><p>anyway a few questions</p><p>1) can you normally use pulled bullets or reuse them as the case may be?</p><p>2) i assume if you can use them as spoilers or break in rounds as they are not lilkely to be as concentric as others?</p><p>3) should i toss them all together or anyother thoguth you may have???</p><p>thanks </p><p>d</p></blockquote><p></p>
[QUOTE="djtjr, post: 402913, member: 13195"] ok i loaded a bunch of bullets to do a ladder test for a gun that i just finished breaking in and going to my car i dropped the bullets and they sacttered :'( anyway i obviously have to start over so i pulled the bullets and began from scratch. i had to use a 6mm sinclair puller the plier type and they were 6.5mm bullets but it seemed to work. as i re seated the bullets i noticed my seating dei was scaring the edges of most of these previously pulled bullets but not new ones. so it seams the pulling or clamping of the bullet took them out of round slightly and i confirmed this with a mic. anyway a few questions 1) can you normally use pulled bullets or reuse them as the case may be? 2) i assume if you can use them as spoilers or break in rounds as they are not lilkely to be as concentric as others? 3) should i toss them all together or anyother thoguth you may have??? thanks d [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
pulled bullet questions???
Top