Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Problem mounting in new stock.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Gone Ballistic" data-source="post: 2102536" data-attributes="member: 26477"><p>Need a little help and advice folks. I recently purchased a McMillan MC3 stock to fit a Remington 700 BDL bottom floor plate magazine and when I tighten the screws down, I can't lift the bolt. I have checked everything I can think of to see what is binding it. The only thing that I can see is it might be pushing the magazine liner up but, can't find a mark on anything, anywhere. If you have had a similar experience and can advise me on how to correct it, I would greatly appreciate it.</p></blockquote><p></p>
[QUOTE="Gone Ballistic, post: 2102536, member: 26477"] Need a little help and advice folks. I recently purchased a McMillan MC3 stock to fit a Remington 700 BDL bottom floor plate magazine and when I tighten the screws down, I can't lift the bolt. I have checked everything I can think of to see what is binding it. The only thing that I can see is it might be pushing the magazine liner up but, can't find a mark on anything, anywhere. If you have had a similar experience and can advise me on how to correct it, I would greatly appreciate it. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Problem mounting in new stock.
Top