Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Portable table
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="emp1953" data-source="post: 2592110" data-attributes="member: 71817"><p><u>Since I wasn't doing full on reloading</u> with my set up, no full length sizing, seating primers etc, I did mount it to a short length of 2X10 which I bolted to the frame that went into the hitch receiver. The RCBS mounting base has a slot on each side for mounting. I used 3/8 lag bolts fed in from the bottom and large wing nuts with washers and lock washers on the top. Easy peasy to set up and break down. Plywood would probably work ok, just don't leave a deep unsupported overhang that the press is bolted to. Maybe double up 3/4 plywood, glued and screwed together.</p></blockquote><p></p>
[QUOTE="emp1953, post: 2592110, member: 71817"] [U]Since I wasn't doing full on reloading[/U] with my set up, no full length sizing, seating primers etc, I did mount it to a short length of 2X10 which I bolted to the frame that went into the hitch receiver. The RCBS mounting base has a slot on each side for mounting. I used 3/8 lag bolts fed in from the bottom and large wing nuts with washers and lock washers on the top. Easy peasy to set up and break down. Plywood would probably work ok, just don't leave a deep unsupported overhang that the press is bolted to. Maybe double up 3/4 plywood, glued and screwed together. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Portable table
Top