Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
OAL and TTL IMPoRTANCE??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jcooper1389" data-source="post: 645582" data-attributes="member: 45997"><p>im fairly new to reloading and i have a few questions</p><p> </p><p>How important is the Overall Length of a fully completed round?</p><p> </p><p>How important in the Trim to Length?</p><p> </p><p>Can there be a .001" variation between brass?</p><p> </p><p>EX> .243 should be 2.025"OAL with HDY 65gr Vmax and sometimes i mess up and seat the bullet to 2.024 or 2.023..i also shave .001" too much sometimes while trimming.</p><p> </p><p>Long Question</p><p> </p><p>I had 10 rounds all perfect TTL and when i seat one bullet perfect my logic tells me that i shouldnt have to adjust the seating die and just push em through but sometimes its off and the bullet is seated too far already.why is this happening?</p><p> </p><p>How Precise does all the measurement have to be to keep consistency..obviously if theyre all the same itll be consistant but if i have the .001-.002 difference does that have an effect??</p></blockquote><p></p>
[QUOTE="jcooper1389, post: 645582, member: 45997"] im fairly new to reloading and i have a few questions How important is the Overall Length of a fully completed round? How important in the Trim to Length? Can there be a .001" variation between brass? EX> .243 should be 2.025"OAL with HDY 65gr Vmax and sometimes i mess up and seat the bullet to 2.024 or 2.023..i also shave .001" too much sometimes while trimming. Long Question I had 10 rounds all perfect TTL and when i seat one bullet perfect my logic tells me that i shouldnt have to adjust the seating die and just push em through but sometimes its off and the bullet is seated too far already.why is this happening? How Precise does all the measurement have to be to keep consistency..obviously if theyre all the same itll be consistant but if i have the .001-.002 difference does that have an effect?? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
OAL and TTL IMPoRTANCE??
Top