Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
New to reloading...issue with FL RCBS die
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MontanaRifleman" data-source="post: 909603" data-attributes="member: 11717"><p>Nothing there that should affect your brass. Why do you sonic clean after sizing?</p><p></p><p>My steps,</p><p></p><p>Insert neck part way into tub of Unique and twist, careful not to get too much lube on inside of neck, then rub a very small amount on case wall. This lubes inside of neck to reduce runout from expander.</p><p></p><p>Decap and size.</p><p></p><p>Clean neck and shoulder with green scotch cleaning pad.</p><p></p><p>Wipe off case with paper towel.</p><p></p><p>Using Q-tip, remove any lube from inside of neck and shoulder area.</p><p></p><p>Clean primer pockets.</p><p></p><p>Run and twist small punch through flash hole.</p><p></p><p>Measure case OAL and trim if necessary. Chamfer mouth inside and out if trimmed.</p><p></p><p>Seat primers... ready to load.</p><p></p><p>I very seldom clean cases anymore. The Unique lube does a good job of that when it is wiped off.</p><p></p><p>Not sure what is going on, but it sounds like there is some sort of inconsistency in your sizing process. You check your press, shell holder, dies etc, to make sure they are in good working order and not loose.</p></blockquote><p></p>
[QUOTE="MontanaRifleman, post: 909603, member: 11717"] Nothing there that should affect your brass. Why do you sonic clean after sizing? My steps, Insert neck part way into tub of Unique and twist, careful not to get too much lube on inside of neck, then rub a very small amount on case wall. This lubes inside of neck to reduce runout from expander. Decap and size. Clean neck and shoulder with green scotch cleaning pad. Wipe off case with paper towel. Using Q-tip, remove any lube from inside of neck and shoulder area. Clean primer pockets. Run and twist small punch through flash hole. Measure case OAL and trim if necessary. Chamfer mouth inside and out if trimmed. Seat primers... ready to load. I very seldom clean cases anymore. The Unique lube does a good job of that when it is wiped off. Not sure what is going on, but it sounds like there is some sort of inconsistency in your sizing process. You check your press, shell holder, dies etc, to make sure they are in good working order and not loose. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
New to reloading...issue with FL RCBS die
Top