Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
New Rifle and Bedding job!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jsthntn247" data-source="post: 1074816" data-attributes="member: 14894"><p>The best way to do it is bed the pillars first then skim bed the action with the screws torqued on the pillars. If skim bedding a block I use one piece of tape wrapped near the rear action screw to keep the tang from lifting. I believe zip ties can cause flex, if your action and barrel are setting level by the amount of tape you put in the front of the barrel channel, you don't need much to keep it from lifting.</p></blockquote><p></p>
[QUOTE="jsthntn247, post: 1074816, member: 14894"] The best way to do it is bed the pillars first then skim bed the action with the screws torqued on the pillars. If skim bedding a block I use one piece of tape wrapped near the rear action screw to keep the tang from lifting. I believe zip ties can cause flex, if your action and barrel are setting level by the amount of tape you put in the front of the barrel channel, you don't need much to keep it from lifting. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
New Rifle and Bedding job!
Top