Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Nesika Bay actions........
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="daveosok" data-source="post: 23974"><p>Yes. We have a Mitsubishi FX30 with the AE power supply. The AE power supply switches between AC and DC giving you a less HAZ area.</p><p>It has a 30 X 20 table with the optional 17.9 Z axis, automatic wire threader, we can use .008, .010 and .012 thou wire.</p><p>We have the optional 32 pound spool capacity too.</p><p>This machine was top of the line when ordered about three years ago, the only difference between it and the new Mits machine that took its place is a 12 to 15 second wire thread operation whereas ours takes a bit longer.</p><p>It will also cut up to a 27.5 degree angle, with the angle cutting diamond dies we can do 45 degrees.</p><p>Ive cut carbide in it, Al, Steel (all kinds), and Ti.</p><p>Ti cuts like butter a lot like Al.</p><p>It will produce a 10 to 12 micro finish, with the optional .003 thou wire setup which we do not have it will produce surface finishes down to 3 and 4 microfinish.</p><p>We have DNC software, MasterCAM, Esprit Wire, FeatureCAM, and I use AutoCAD 2000i.</p><p>The MasterCAM is the complete package (wire, mill, lathe, and mill 3d) with solid modeling.</p><p></p><p>[ 12-09-2002: Message edited by: daveosok ]</p></blockquote><p></p>
[QUOTE="daveosok, post: 23974"] Yes. We have a Mitsubishi FX30 with the AE power supply. The AE power supply switches between AC and DC giving you a less HAZ area. It has a 30 X 20 table with the optional 17.9 Z axis, automatic wire threader, we can use .008, .010 and .012 thou wire. We have the optional 32 pound spool capacity too. This machine was top of the line when ordered about three years ago, the only difference between it and the new Mits machine that took its place is a 12 to 15 second wire thread operation whereas ours takes a bit longer. It will also cut up to a 27.5 degree angle, with the angle cutting diamond dies we can do 45 degrees. Ive cut carbide in it, Al, Steel (all kinds), and Ti. Ti cuts like butter a lot like Al. It will produce a 10 to 12 micro finish, with the optional .003 thou wire setup which we do not have it will produce surface finishes down to 3 and 4 microfinish. We have DNC software, MasterCAM, Esprit Wire, FeatureCAM, and I use AutoCAD 2000i. The MasterCAM is the complete package (wire, mill, lathe, and mill 3d) with solid modeling. [ 12-09-2002: Message edited by: daveosok ] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Nesika Bay actions........
Top