Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck sizing with FL dies
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Joe King" data-source="post: 688708" data-attributes="member: 47325"><p>thats why I said can. I've never had a problem using FL dies, as far a shaving jackets I've never seen it, one time just for ***** n giggles I seated a .308 165gr GK in a 7mm case, just to see if it would actually seat or if something else happened...........it seated. I was pretty surprised, but I chamfer my case mouths very well. Jacketed bullets are swagged under 100k psi, I really doubt a thin brass tube is going to have any real effect on the <u>bullets </u>concentricity, just not enough pressure there. My RCBS FL dies for my 270 make the neck smaller than 0.002 under, about 0.004 under IIRC after the expander ball. (been a while since I checked it, no need to everything works up to snuff)</p></blockquote><p></p>
[QUOTE="Joe King, post: 688708, member: 47325"] thats why I said can. I've never had a problem using FL dies, as far a shaving jackets I've never seen it, one time just for ***** n giggles I seated a .308 165gr GK in a 7mm case, just to see if it would actually seat or if something else happened...........it seated. I was pretty surprised, but I chamfer my case mouths very well. Jacketed bullets are swagged under 100k psi, I really doubt a thin brass tube is going to have any real effect on the [U]bullets [/U]concentricity, just not enough pressure there. My RCBS FL dies for my 270 make the neck smaller than 0.002 under, about 0.004 under IIRC after the expander ball. (been a while since I checked it, no need to everything works up to snuff) [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck sizing with FL dies
Top