Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck sizing and turning order (stupid question)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="elf" data-source="post: 1662086" data-attributes="member: 103580"><p>Some good tips here. Just wanna add - trimming to same OAL is important so that your trimmer stop is at same point each time. Set trimmer stop so that the cut ends exactly at the neck-shoulder junction. If you know the diameter of your chamber, keep a loaded round .002 - .003" below that (test first with a dummy round). Prepare to have a few throw away brass, cause you will most likely make some errors. Go to youtube and watch video first. Good luck.</p></blockquote><p></p>
[QUOTE="elf, post: 1662086, member: 103580"] Some good tips here. Just wanna add - trimming to same OAL is important so that your trimmer stop is at same point each time. Set trimmer stop so that the cut ends exactly at the neck-shoulder junction. If you know the diameter of your chamber, keep a loaded round .002 - .003" below that (test first with a dummy round). Prepare to have a few throw away brass, cause you will most likely make some errors. Go to youtube and watch video first. Good luck. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck sizing and turning order (stupid question)
Top