Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Coyote Hunting - From 10 Yards to over 1,000 Yards
Maximum point blank range 0-400
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mike Matteson" data-source="post: 2724129" data-attributes="member: 101791"><p>I know the converting brass neck size is some work. I change 280AI to 6mm/280AI cases. It takes 4 steps to achieve that size. I am using Redding 280AI bushing dies. I have 4 sizing dies, for not having change out the bushing each time. I also had to change out the decapping rod kit to 25/06 in the 280AI dies. The rods are a larger thread DI so they will not change. The decapping rod in the 208AI will not fit inside the necks after sizing a down a step. I cut the necks for thickness in 2 steps. My reamer end up a little smaller and what I wanted. It's okay. I having to cut to .0125th instead of 13th. Annealing the case between the 2nd and 3rd step. </p><p>(All new Brass/Never been fired) I cut my necks before anything else for thickness. I also crush a couple of cases in getting the sizing steps down. </p><p>Once fired cases I would anneal before anything else. </p><p>Hope that helps.</p></blockquote><p></p>
[QUOTE="Mike Matteson, post: 2724129, member: 101791"] I know the converting brass neck size is some work. I change 280AI to 6mm/280AI cases. It takes 4 steps to achieve that size. I am using Redding 280AI bushing dies. I have 4 sizing dies, for not having change out the bushing each time. I also had to change out the decapping rod kit to 25/06 in the 280AI dies. The rods are a larger thread DI so they will not change. The decapping rod in the 208AI will not fit inside the necks after sizing a down a step. I cut the necks for thickness in 2 steps. My reamer end up a little smaller and what I wanted. It's okay. I having to cut to .0125th instead of 13th. Annealing the case between the 2nd and 3rd step. (All new Brass/Never been fired) I cut my necks before anything else for thickness. I also crush a couple of cases in getting the sizing steps down. Once fired cases I would anneal before anything else. Hope that helps. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Coyote Hunting - From 10 Yards to over 1,000 Yards
Maximum point blank range 0-400
Top