Manners PRS1 with Mini Chassis and MPA Rail - $700

[jamiebolseth]

I have a Manners PRS1 Mini Chassis stock. It's for a S/A Rem 700, but has had the bolt handle recess, Side bolt release, and ejection port professionally relieved so that it will fit any other Rem700 clone action like Surgeon, Defiance, Bighorn, Mausingfield, etc. The barrel channel will take up to a M24 contour. As you can see these areas in the pictures these areas were milled out and then covered with gray Marine Tech epoxy. This stock has the carbon fiber barrel channel, and the MPA rail with barricade stop and block. It also has an Area 419 pic rail added for a bipod or other attachments. Overall the stock is in good condition with only minor bumps and scrapes that you would see from competition use.

I'm selling this Stock for $700 shipped. Possible trades are listed below, otherwise I'd prefer PayPal Friends and Family (or add 3% for the fees). If this post isn't marked as Sold, or Sold Pending Funds they are still available.

NOTE: the green tape on the stock isn't covering anything up. It's just holding the action screws on so they don't get lost.


Thanks,



Possible trade include the following...
Some reloading supplies I could use...
CCI rifle primers of any size
308 cal ELDx 178 grain bullets
6.5 cal Berger 140 grain Elite Hunters
6.5 cal ELDx 143 grain
7mm cal Berger 175 Elite Hunters

Powders...
Varget, H1000, IMR 4198, RL26, RL16, H4350

Ammo...
Fiochhi Gold Pheasant 12 gauge loads in 4's or 5's (or similar pheasant loads like Federal Prairie Storm)
9mm pistol ammo
45 ACP pistol ammo

 

[Deleted member 48126]

Smoking deal...holy crap.

 

[songdogslayer]

I'll take this

 

[jamiebolseth]

This is SOLD to SongDogSlayer. Thanks.