Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Making a custom stock
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="JPaul17" data-source="post: 897746" data-attributes="member: 40536"><p>Got a little bit further tonight with getting the rear tang area flush. Also tried to create a flute so I can get to the safety without having to move my hand very much. Finally got the trigger to seat properly and nothing it catching. Next I'll have to remove about a 1/4" from the bottom of the stock to allow the trigger to reach through. Once that's done I'll inlet for the magazine and start the pillars and move onto glass bedding. After that's over with I'm home free and will just cut the for end about an inch, round the tip, and add my swivels. Starting to see the light at the end of the tunnel and am getting anxious. Can't wait to finish it up and get out to shoot it before I head back to school.</p></blockquote><p></p>
[QUOTE="JPaul17, post: 897746, member: 40536"] Got a little bit further tonight with getting the rear tang area flush. Also tried to create a flute so I can get to the safety without having to move my hand very much. Finally got the trigger to seat properly and nothing it catching. Next I'll have to remove about a 1/4" from the bottom of the stock to allow the trigger to reach through. Once that's done I'll inlet for the magazine and start the pillars and move onto glass bedding. After that's over with I'm home free and will just cut the for end about an inch, round the tip, and add my swivels. Starting to see the light at the end of the tunnel and am getting anxious. Can't wait to finish it up and get out to shoot it before I head back to school. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Making a custom stock
Top