Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
I need a little help finding a case trimmer....
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BigJakeJ1s" data-source="post: 268900" data-attributes="member: 12889"><p>Without the micrometer adjustment, the stand, or the shark fin, the base trimmer is < $40, and case holders are ~ $8 ea or less, making it a very cost effective trimmer, if you're on a budget. I just clamp mine in the small bench vise on my reloading bench. If I did not have the vise, a simple wooden base would be easy to make. You just need to elevate it enough so that you can turn the crank. I've had no problems holding the caseholder on the rails with my left hand while turning the crank with my right. Wilson also offers a power adapter so you can use a cordless drill or screwdriver to turn the cutter. Without the micrometer, it takes a little longer to set up the trim length, but it is no less accurate or repeatable. </p><p></p><p>I really like the walnut/maple(?) base shown above. The maple(?) block is a nice touch, handy for knocking the cases into or out of the case holder.</p><p></p><p>Andy</p></blockquote><p></p>
[QUOTE="BigJakeJ1s, post: 268900, member: 12889"] Without the micrometer adjustment, the stand, or the shark fin, the base trimmer is < $40, and case holders are ~ $8 ea or less, making it a very cost effective trimmer, if you're on a budget. I just clamp mine in the small bench vise on my reloading bench. If I did not have the vise, a simple wooden base would be easy to make. You just need to elevate it enough so that you can turn the crank. I've had no problems holding the caseholder on the rails with my left hand while turning the crank with my right. Wilson also offers a power adapter so you can use a cordless drill or screwdriver to turn the cutter. Without the micrometer, it takes a little longer to set up the trim length, but it is no less accurate or repeatable. I really like the walnut/maple(?) base shown above. The maple(?) block is a nice touch, handy for knocking the cases into or out of the case holder. Andy [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
I need a little help finding a case trimmer....
Top