Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
How much torque
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="redneckdan" data-source="post: 1841162" data-attributes="member: 8932"><p>I use the action screws to pull it down to the stock, finger tight. Maybe 5 inch pounds if that. Then I wrap electrical tape around the action and stock to provide tension, at this point the action screws are usually loose again and I leave them that way. After 24 hours I disassemble, clean up and let it set for another week or so to fully cure. Then I torque using a procedure similar to the guy further up the thread.</p></blockquote><p></p>
[QUOTE="redneckdan, post: 1841162, member: 8932"] I use the action screws to pull it down to the stock, finger tight. Maybe 5 inch pounds if that. Then I wrap electrical tape around the action and stock to provide tension, at this point the action screws are usually loose again and I leave them that way. After 24 hours I disassemble, clean up and let it set for another week or so to fully cure. Then I torque using a procedure similar to the guy further up the thread. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
How much torque
Top