Hornady data 28 nos 180 eld

[fisherman983]

Can someone screenshot the load data page from hornady for the 180 eld-m and 28 nosler.
Needing a fee measurements and starting place in powder charge

 

[scdogman]

Hornady doesn't recognize the 28 nosler. I would start at .030 from the lands and with 76 grains of h1000 and work up.

I'm running around 79 grains.

 

[bsaoneshot]

I am running Retumbo at 80 grains with the 180 ELDMs. Had pressure signs at 82. H1000 was too slow for my barrel. Going to try IMR833 this week end, starting at 78 grains to 82 grains.

 

[Kmccord]

You can try the min and Max load data for 180 Berger. I did that to get a starting load and maximum load from Hodgon website for the new IMR 8133 powder. I don't see why that would not work for other powders as well.

 

[257Tony]

Mine likes 86 or rl33, at 3.58 coal. 3200 fps out of my 26" x-bolt.

 

[scdogman]

I found H1000 to super accurate and never went back to Retumbo. r33 is not temp stable and is said to leave a lot of fouling. I believe it requires often cleaning or you will run into pressure issues with your normal loads. Many have switched from r33 to N570 but it's hard to find. Google the posts by one of the 28 nosler producing king. I say king with much respect. If I was to have a rifle built, he would be my builder.

H1000 is running at 3114 for me.

 

[awesymoto]

24" bartlein 77.9 h1000 .02 jump got 3022 with 175 eldx and 78.7 went 3110 magneto speed chrono used. NOTE 78.7 IS HOT in my gun and 78.9 had sticky bolt lift