Hogue Overmolded stock for Winchester model 70 WSM calibers. This was on a Classic Stainless 300 WSM and worked well. Full length aluminum bedding block and pillars. Standard length of pull.
The bottom metal area has been inletted deeper to accept the factory one piece bottom metal. I think the problem was, the stock was originally made for 2 piece bottom metal, which is thinner, and didn't work with the thicker one piece metal. So, it had to be inletted deeper to work. There are a few gouges in the rubber around the bottom inletting, which probably could be fixed. But, it's a good stock for bad weather, or a "beater", and is way more solid than the factory composite.
$75 shipped. This was a $250 stock. Paypal accepted and included.
The bottom metal area has been inletted deeper to accept the factory one piece bottom metal. I think the problem was, the stock was originally made for 2 piece bottom metal, which is thinner, and didn't work with the thicker one piece metal. So, it had to be inletted deeper to work. There are a few gouges in the rubber around the bottom inletting, which probably could be fixed. But, it's a good stock for bad weather, or a "beater", and is way more solid than the factory composite.
$75 shipped. This was a $250 stock. Paypal accepted and included.
