SOLD/EXPIRED HENDERSON GEN 3 CASE BRASS TRIMMER, 243 (6mm) cutter, 308 cutter, Brass Bin, Drive Motor

[JPatzig]

Great trimmer, but I don't reload enough volume to justify keeping it. All of it is like new, I have only trimmed around 20 cases, on the 6mm cutter. On the 6mm cutter, I turned the pilot diameter down to .238" (I run tight neck tension). You can buy a new one at full diameter from Henderson for $5. The 308 cutter is new, unused. Below is everything included for $550. All original parts included. I can potentially part it out, if you don't want both or either cutter.

For $75, I can also include an A/C motor I used to drive the trimmer. It's powerful and runs at 1800rpm, perfect for this trimmer.

($550) HENDERSON GEN 3 CASE TRIMMER
2 x Collets: #3 and #1
2 x Cutters: 243 (6mm) Adjusted and 308 Adjusted
1 x Brass Bin & Shaving Containment

($75)
1800rpm A/C Motor
LoveJoy Coupler

Can meet locally in Fort Worth TX, or ship for $25 UPS Ground in original box.

 

[JPatzig]

TTT

 

[JPatzig]

Bump

 

[Coyote Shadow Tracker]

Great trimmer, but I don't reload enough volume to justify keeping it. All of it is like new, I have only trimmed around 20 cases, on the 6mm cutter. On the 6mm cutter, I turned the pilot diameter down to .238" (I run tight neck tension). You can buy a new one at full diameter from Henderson for $5. The 308 cutter is new, unused. Below is everything included for $550. All original parts included. I can potentially part it out, if you don't want both or either cutter.

For $75, I can also include an A/C motor I used to drive the trimmer. It's powerful and runs at 1800rpm, perfect for this trimmer.

($550) HENDERSON GEN 3 CASE TRIMMER
2 x Collets: #3 and #1
2 x Cutters: 243 (6mm) Adjusted and 308 Adjusted
1 x Brass Bin & Shaving Containment

($75)
1800rpm A/C Motor
LoveJoy Coupler

Can meet locally in Fort Worth TX, or ship for $25 UPS Ground in original box.

GREAT TRIMMER!!!

 

[cal hunter]

still available?

 

[JPatzig]

still available?

Yes

 

[cal hunter]

is that an aftermarket motor? it doesn't look like the one on their website

 

[JPatzig]

is that an aftermarket motor? it doesn't look like the one on their website

Yes, aftermarket. It's an A/C motor that came off a lathe I had in the past. It runs at 1800rpm, the recommended speed for the cutter. It's a bigger motor than the one Henderson sells

 

[Comhertz]

PM Sent

 

[Comhertz]

Profile message sent. I have not figured out how to start a "conversation" aka a "PM" on this site.

 

[JPatzig]

Profile message sent. I have not figured out how to start a "conversation" aka a "PM" on this site.

You need more posts before you can send a PM. I responded to your profile message, can you email me?

 

[Comhertz]

You need more posts before you can send a PM. I responded to your profile message, can you email me?

email sent

 

[Mike D Texas]

Wow. If by some chance this is still available I'm local and interested.