Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Forming 300 Ultra Brass from 404 Jeffery
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="steve smith" data-source="post: 21292" data-attributes="member: 110"><p>A less expensive route would be to get redding form and trim dies in 375 and 338 ultra mag. Then run it through a 300fl die. Let the 375 set the head space and adjust the 338 so to just touch the shoulder. I used the 375, 338, 300, and 7mm to form 270x300ultra mag and it works quite well.</p></blockquote><p></p>
[QUOTE="steve smith, post: 21292, member: 110"] A less expensive route would be to get redding form and trim dies in 375 and 338 ultra mag. Then run it through a 300fl die. Let the 375 set the head space and adjust the 338 so to just touch the shoulder. I used the 375, 338, 300, and 7mm to form 270x300ultra mag and it works quite well. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Forming 300 Ultra Brass from 404 Jeffery
Top