Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Deforming Nozler Accubond bullet tips
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="28_Nosler" data-source="post: 1956839" data-attributes="member: 114757"><p>Just a guess but could it be that the inside dimensions of the neck area in your Reeding Competition seater die a little tight and when trying to seat a bullet in the case won't allow the neck to expand out enough in the die. I know that Lapua brass is pretty thick and my 6.5-284 Norma rifle chamber won't take a case neck that thick so I have to cut each case neck down about 0.001" around. I have never tried to seat a bullet in a un-preped case for my 6.5-284. I just measured my new Lapua brass neck thickness to be 0.016" and my cut necks to be 0.015". My suggestion would be to cut the case neck and try to seat a bullet then. This may cure your problem. Another thing that you may want to do is to call Redding and ask them what the dimension is in the neck area of your seating die.</p></blockquote><p></p>
[QUOTE="28_Nosler, post: 1956839, member: 114757"] Just a guess but could it be that the inside dimensions of the neck area in your Reeding Competition seater die a little tight and when trying to seat a bullet in the case won't allow the neck to expand out enough in the die. I know that Lapua brass is pretty thick and my 6.5-284 Norma rifle chamber won't take a case neck that thick so I have to cut each case neck down about 0.001" around. I have never tried to seat a bullet in a un-preped case for my 6.5-284. I just measured my new Lapua brass neck thickness to be 0.016" and my cut necks to be 0.015". My suggestion would be to cut the case neck and try to seat a bullet then. This may cure your problem. Another thing that you may want to do is to call Redding and ask them what the dimension is in the neck area of your seating die. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Deforming Nozler Accubond bullet tips
Top