Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Changing Bushings After Annealing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Canadian Bushman" data-source="post: 978388" data-attributes="member: 41122"><p>I believe the thinking here is that by annealing the brass you have reduced neck tension and thrown your load off by just a bit. </p><p></p><p>Ive seen and heard of this quite a few times so id consider it a common problem. </p><p></p><p>I think it can be a little more complicated than just neck tension because when we anneal other processes of our reloading tend to have a different effect. I.E. the case springs back from sizing less, and the surface of the brass is "grippy-er", and sometimes we even clean them more to rid the annealed look. </p><p></p><p>You can try what the guys at benchsource suggested, but you need to also decide how often you plan to anneal as well. I chose to rarely anneal because i dont work my necks very hard and my loads seem more consistent when i dont. Some guys choose to anneal every load, and tune their load to that condition.</p></blockquote><p></p>
[QUOTE="Canadian Bushman, post: 978388, member: 41122"] I believe the thinking here is that by annealing the brass you have reduced neck tension and thrown your load off by just a bit. Ive seen and heard of this quite a few times so id consider it a common problem. I think it can be a little more complicated than just neck tension because when we anneal other processes of our reloading tend to have a different effect. I.E. the case springs back from sizing less, and the surface of the brass is "grippy-er", and sometimes we even clean them more to rid the annealed look. You can try what the guys at benchsource suggested, but you need to also decide how often you plan to anneal as well. I chose to rarely anneal because i dont work my necks very hard and my loads seem more consistent when i dont. Some guys choose to anneal every load, and tune their load to that condition. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Changing Bushings After Annealing
Top