Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case polishing and annealing?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Barrelnut" data-source="post: 2970817" data-attributes="member: 74902"><p>That Glenn Kulzer article was a good read. </p><p>As far as his lack of annealing, I would say that he's running a match chamber with a tight neck, matched to Alpha brass specs. So the necks don't get a lot of work. He mentions that Alex Wheeler built the rifle. So I'm assuming it's a special reamer and the dies were probably cut from that same reamer.</p><p>Most hunters are probably using SAAMI spec chambers so there's a lot more room for the necks to expand and work harden. So frequent annealing might be beneficial.</p></blockquote><p></p>
[QUOTE="Barrelnut, post: 2970817, member: 74902"] That Glenn Kulzer article was a good read. As far as his lack of annealing, I would say that he's running a match chamber with a tight neck, matched to Alpha brass specs. So the necks don't get a lot of work. He mentions that Alex Wheeler built the rifle. So I'm assuming it's a special reamer and the dies were probably cut from that same reamer. Most hunters are probably using SAAMI spec chambers so there's a lot more room for the necks to expand and work harden. So frequent annealing might be beneficial. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case polishing and annealing?
Top