Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case lube removal
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="biednick" data-source="post: 2860425" data-attributes="member: 123604"><p>You can't be sure it's not caused by too much powder just because it's below book max. Drop the charge until the problem goes away then back off a little more. On the off chance a thin film of lube puts it over pressure you're way too close to the edge anyway. A temperate swing or a little moisture will push it back over the edge. </p><p></p><p>To answer your question on lube, 15 minutes or so in a vibratory tumbler with walnut shells will do it. I do that for bottleneck loads done on a progressive press. On a single stage it's easy enough to tumble after sizing.</p></blockquote><p></p>
[QUOTE="biednick, post: 2860425, member: 123604"] You can't be sure it's not caused by too much powder just because it's below book max. Drop the charge until the problem goes away then back off a little more. On the off chance a thin film of lube puts it over pressure you're way too close to the edge anyway. A temperate swing or a little moisture will push it back over the edge. To answer your question on lube, 15 minutes or so in a vibratory tumbler with walnut shells will do it. I do that for bottleneck loads done on a progressive press. On a single stage it's easy enough to tumble after sizing. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case lube removal
Top