Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
bullet trap, bullet stopper, hanging target specs needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="d11r529" data-source="post: 959429" data-attributes="member: 26177"><p>I had a 1 inch thick mild steel plate at 600 yards, it's set so that my bullets hit it straight on. My 300 win mag with 168 gr berger hunting bullets will blow a crater in it just shy of 1/2 way through. I have gone to 1/2 inch ar 500 steel plates and from 300 yards and out all it does is blow the paint off, just repaint and you can't even tell it was hit before. If your concerned about bullet splatter, a friend of mine hangs his plates inside of old tires (tractor tires for the bigger long range plates). ??????? hope this helps</p></blockquote><p></p>
[QUOTE="d11r529, post: 959429, member: 26177"] I had a 1 inch thick mild steel plate at 600 yards, it's set so that my bullets hit it straight on. My 300 win mag with 168 gr berger hunting bullets will blow a crater in it just shy of 1/2 way through. I have gone to 1/2 inch ar 500 steel plates and from 300 yards and out all it does is blow the paint off, just repaint and you can't even tell it was hit before. If your concerned about bullet splatter, a friend of mine hangs his plates inside of old tires (tractor tires for the bigger long range plates). ??????? hope this helps [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Equipment Discussions
bullet trap, bullet stopper, hanging target specs needed
Top