Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
brass sizing question?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="flashhole" data-source="post: 394565" data-attributes="member: 21375"><p>I'm in the annealing camp but I gotta tell ya the Hornady dies are on the long side. I have several sets and get minimum shoulder bump with all of them. You can put a shim under the base of the brass when in the shell holder to take up some slop or reduce the height of your shell holder by .002" -.003", either method sends the brass into to the die a bit deeper.</p></blockquote><p></p>
[QUOTE="flashhole, post: 394565, member: 21375"] I'm in the annealing camp but I gotta tell ya the Hornady dies are on the long side. I have several sets and get minimum shoulder bump with all of them. You can put a shim under the base of the brass when in the shell holder to take up some slop or reduce the height of your shell holder by .002" -.003", either method sends the brass into to the die a bit deeper. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
brass sizing question?
Top