Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Boyd's
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Alibiiv" data-source="post: 1697990" data-attributes="member: 69192"><p>Barrelnut, thanks for sharing this one about using the aluminum lamp stand tubes, I'll have to look in to that one. I used a pillar block kit from Brownell's, however I have Ruger 77s and found that the front pillar was not long enough to make contact from the hinge plate to the recoil lug. The pillar was notched to fit into the recoil lug (angled), however it fell short by at lease 1/32nd to meet the floor-plate hinge. For my next one I was going to get some 1/2 inch aluminum bar stock and make my own.</p></blockquote><p></p>
[QUOTE="Alibiiv, post: 1697990, member: 69192"] Barrelnut, thanks for sharing this one about using the aluminum lamp stand tubes, I'll have to look in to that one. I used a pillar block kit from Brownell's, however I have Ruger 77s and found that the front pillar was not long enough to make contact from the hinge plate to the recoil lug. The pillar was notched to fit into the recoil lug (angled), however it fell short by at lease 1/32nd to meet the floor-plate hinge. For my next one I was going to get some 1/2 inch aluminum bar stock and make my own. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Boyd's
Top