Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding using only action,barrel weight
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MNbogboy" data-source="post: 1773317" data-attributes="member: 18849"><p>My method has been using long studs wrapped with tape to center them in the pillars/bedding block. The action is held by hand tight torque on the nut/washer combination screwed on the studs for the "cure" time. Removal after curing by "double nutting" them.</p><p>Also wrapping the barrel with tape near the front of the stock to center it as Dosh mentioned. Tape being no thicker than the clearance in the un-bedded state.</p><p>I do not bed the tang as well.</p></blockquote><p></p>
[QUOTE="MNbogboy, post: 1773317, member: 18849"] My method has been using long studs wrapped with tape to center them in the pillars/bedding block. The action is held by hand tight torque on the nut/washer combination screwed on the studs for the "cure" time. Removal after curing by "double nutting" them. Also wrapping the barrel with tape near the front of the stock to center it as Dosh mentioned. Tape being no thicker than the clearance in the un-bedded state. I do not bed the tang as well. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding using only action,barrel weight
Top