Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding using only action,barrel weight
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="rsbhunter" data-source="post: 1773028" data-attributes="member: 5850"><p>I've always been curious about the not bedding the tang....I figured it was because of the safety area.....but being a tube receiver, it is confusing....unless the action flex's or???? Any way , I plan on putting about a 1/64" or less if possible layer on the block, and fill the recoil lug area almost full...I'll clean out the bbl nut area after(but still put one layer of elec tape around the nut) just to be sure. I will put tape around the mid point of bbl to center it..would like to see pics....rsbhunter</p></blockquote><p></p>
[QUOTE="rsbhunter, post: 1773028, member: 5850"] I've always been curious about the not bedding the tang....I figured it was because of the safety area.....but being a tube receiver, it is confusing....unless the action flex's or???? Any way , I plan on putting about a 1/64" or less if possible layer on the block, and fill the recoil lug area almost full...I'll clean out the bbl nut area after(but still put one layer of elec tape around the nut) just to be sure. I will put tape around the mid point of bbl to center it..would like to see pics....rsbhunter [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding using only action,barrel weight
Top