Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Chatting and General Stuff
General Discussion
Barrel contour question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="SDWhirlwind" data-source="post: 119049" data-attributes="member: 1781"><p>Shilen #5 muzzle dia @ 26" is .725. Remington Varmint contours measure .830 at the muzzle on the PSS, EtronX, VS, VSS and VSSF that I measured. Rock Creek PSS contour meausured .860 at 26". The Shilen and Douglas contours are pretty close. As stated above the Shilen 5.5 is equivalent to the Rem varmint(short action) and Sendero(long action). I beleive the Lilja #5 is a bit heavier than Douglas or Shilen #5 but you can look on their site. So boils down to probably removing a little material entire length of the Mickey stock verses the wait to get factory inletting!!! Shank dia and taper as well as muzzle diameter can vary between barrel makers some despite website listing but not by more than a few thousandths generally.</p></blockquote><p></p>
[QUOTE="SDWhirlwind, post: 119049, member: 1781"] Shilen #5 muzzle dia @ 26" is .725. Remington Varmint contours measure .830 at the muzzle on the PSS, EtronX, VS, VSS and VSSF that I measured. Rock Creek PSS contour meausured .860 at 26". The Shilen and Douglas contours are pretty close. As stated above the Shilen 5.5 is equivalent to the Rem varmint(short action) and Sendero(long action). I beleive the Lilja #5 is a bit heavier than Douglas or Shilen #5 but you can look on their site. So boils down to probably removing a little material entire length of the Mickey stock verses the wait to get factory inletting!!! Shank dia and taper as well as muzzle diameter can vary between barrel makers some despite website listing but not by more than a few thousandths generally. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Chatting and General Stuff
General Discussion
Barrel contour question
Top