Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Barrel channel widening
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="bstomper" data-source="post: 2009960" data-attributes="member: 37250"><p>Didn't really know where to put this so I hope this is the place. I am getting a new barrel for my Model 70, at this point the make of the barrel is still undecided. The barrel I have on it now is the stock sporter type barrel and the one I will be getting is definately goingto be a heavier contoured barrel. I have a wood laminate stock on this rifle and I will be needing to open up the barrel channel to fit the heavier barrel. The stock, which I really like, is a Boyds varmit thumbhole that is pillar and action bedded and the fore end of the stock has plenty of room to fit the new heavy contour. I am looking for suggestions as to what would be the best/ easiest way to remove the material in this area</p></blockquote><p></p>
[QUOTE="bstomper, post: 2009960, member: 37250"] Didn't really know where to put this so I hope this is the place. I am getting a new barrel for my Model 70, at this point the make of the barrel is still undecided. The barrel I have on it now is the stock sporter type barrel and the one I will be getting is definately goingto be a heavier contoured barrel. I have a wood laminate stock on this rifle and I will be needing to open up the barrel channel to fit the heavier barrel. The stock, which I really like, is a Boyds varmit thumbhole that is pillar and action bedded and the fore end of the stock has plenty of room to fit the new heavy contour. I am looking for suggestions as to what would be the best/ easiest way to remove the material in this area [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Barrel channel widening
Top