Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
any load suggestion using 140 gr accubond 7mm rem mag
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Shortmagman" data-source="post: 419111" data-attributes="member: 10723"><p>I have a number of loads that I have shot in my Ruger 77 Mark II. For high velocity I have two different loads that I have shot over a chronograph. First I have loaded Magpro powder, in RP cases, with WLRM primers. You need to work this load up in your gun but at 75 grains my gun produced an average of 3184 ft/sec with the 140 Accubond bullets. Next I have loaded RL-22(70.5 grains) and with this combination the 140 grain Accubonds produced 3150 ft/sec.. You need to work this load up in your gun also. Both of these loads are above the Max listed for these powders. You need to look at the Alliant web site and follow their information. You will find that 66 grains of RL-22 is the Max with a 140 grain bullet. 73.7 is the maX for Magpro so if you use this powder make sure that you follow published data.</p><p></p><p>For an accurate load that produces only about 2900 ft/sec I loaded 62.0 grains of IMR-4350,WLR primers in RP cases.</p></blockquote><p></p>
[QUOTE="Shortmagman, post: 419111, member: 10723"] I have a number of loads that I have shot in my Ruger 77 Mark II. For high velocity I have two different loads that I have shot over a chronograph. First I have loaded Magpro powder, in RP cases, with WLRM primers. You need to work this load up in your gun but at 75 grains my gun produced an average of 3184 ft/sec with the 140 Accubond bullets. Next I have loaded RL-22(70.5 grains) and with this combination the 140 grain Accubonds produced 3150 ft/sec.. You need to work this load up in your gun also. Both of these loads are above the Max listed for these powders. You need to look at the Alliant web site and follow their information. You will find that 66 grains of RL-22 is the Max with a 140 grain bullet. 73.7 is the maX for Magpro so if you use this powder make sure that you follow published data. For an accurate load that produces only about 2900 ft/sec I loaded 62.0 grains of IMR-4350,WLR primers in RP cases. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
any load suggestion using 140 gr accubond 7mm rem mag
Top