Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Annealing Machines
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="dok7mm" data-source="post: 1295610" data-attributes="member: 90080"><p>Depending on your budget, research the AMP annealer. It's made in New Zealand, but is now available from Graf&Sons. I have used the gas units and they take time to setup, when changing calibers, using Tempilac to calibrate each time. Which ever you choose, the induction annealer seem to be replacing a lot of the gas torch type. I am using the AMP unit and have found it to be, by far, the most consistent I have used. Neck sizing and FL sizing are spot on and bullet seating is smooth, after annealing.</p></blockquote><p></p>
[QUOTE="dok7mm, post: 1295610, member: 90080"] Depending on your budget, research the AMP annealer. It's made in New Zealand, but is now available from Graf&Sons. I have used the gas units and they take time to setup, when changing calibers, using Tempilac to calibrate each time. Which ever you choose, the induction annealer seem to be replacing a lot of the gas torch type. I am using the AMP unit and have found it to be, by far, the most consistent I have used. Neck sizing and FL sizing are spot on and bullet seating is smooth, after annealing. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Annealing Machines
Top