Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
annealing brass
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mikecr" data-source="post: 1186322" data-attributes="member: 1521"><p>Annealing(like any single action) isn't right until the barrel/load/results tell you so. The barrel likes a load, the load likes a given tension.</p><p>If your plan is to maintain low neck tension, then it's prudent to anneal as you will continually, including through load development. There needs to be reasons with this plan.</p><p>If shooting a 30-06 with typical sloppy chamber then you know annealing will be needed, might as well begin with it, and find a best load with this.</p><p>If shooting an underbore 6.5x47L, which will like a pressure node, but testing shows best seating off the lands(OTL), then you'll likely need faster powder or neck tension-lots of it, to hit that magic node. In this case I would manage consistent tension, without losing it to annealing. Better chamber and sizing die fitting, to turned necks.</p></blockquote><p></p>
[QUOTE="Mikecr, post: 1186322, member: 1521"] Annealing(like any single action) isn't right until the barrel/load/results tell you so. The barrel likes a load, the load likes a given tension. If your plan is to maintain low neck tension, then it's prudent to anneal as you will continually, including through load development. There needs to be reasons with this plan. If shooting a 30-06 with typical sloppy chamber then you know annealing will be needed, might as well begin with it, and find a best load with this. If shooting an underbore 6.5x47L, which will like a pressure node, but testing shows best seating off the lands(OTL), then you'll likely need faster powder or neck tension-lots of it, to hit that magic node. In this case I would manage consistent tension, without losing it to annealing. Better chamber and sizing die fitting, to turned necks. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
annealing brass
Top