Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Annealeez, need some help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="scpaul" data-source="post: 2902444" data-attributes="member: 76393"><p><strong>true, you might try some "0000" steel wool. Just remember that delicately is the operative word. In the office equipment industry magazines that just about any copier dealer. Will gladly give you. You can get some rollers recoated to a certain delrin(?) Firmness as well as grip.Dont forget the manufacturer's OE</strong></p><p><strong>M. They may still stock rollers. When rollers are old or worn if you place them on a piece of glass you can see defects easier. The ends of the rubber can swell and you can see light/Reflections under the rollers but it doesn't take much. IF you have the room you can use an exact-o knife to carefully trim the edges of the roller in very minor amounts and use a feeler gauge with a light scale to measure the difference in friction. You can also use 2 pieces of paper like thin book marks for the same. Raw paper is best because any finish will vary the tension on the scales. Good luck, Paul</strong></p></blockquote><p></p>
[QUOTE="scpaul, post: 2902444, member: 76393"] [B]true, you might try some "0000" steel wool. Just remember that delicately is the operative word. In the office equipment industry magazines that just about any copier dealer. Will gladly give you. You can get some rollers recoated to a certain delrin(?) Firmness as well as grip.Dont forget the manufacturer's OE M. They may still stock rollers. When rollers are old or worn if you place them on a piece of glass you can see defects easier. The ends of the rubber can swell and you can see light/Reflections under the rollers but it doesn't take much. IF you have the room you can use an exact-o knife to carefully trim the edges of the roller in very minor amounts and use a feeler gauge with a light scale to measure the difference in friction. You can also use 2 pieces of paper like thin book marks for the same. Raw paper is best because any finish will vary the tension on the scales. Good luck, Paul[/B] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Annealeez, need some help
Top