Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6mm HLS case formimg help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="can1010" data-source="post: 2079608" data-attributes="member: 43193"><p>that is because you are trying to go straight to 6mm. you need to use intermediate steps. use a 308 die to set the body shoulder close to where you want it, then start necking it down and setting shoulder angle and neck shoulder junction where you want. don't anneal if using new brass but if using older brass to help set up dies then you will want to anneal. it is tough to move that much body at 6mm in one step</p></blockquote><p></p>
[QUOTE="can1010, post: 2079608, member: 43193"] that is because you are trying to go straight to 6mm. you need to use intermediate steps. use a 308 die to set the body shoulder close to where you want it, then start necking it down and setting shoulder angle and neck shoulder junction where you want. don't anneal if using new brass but if using older brass to help set up dies then you will want to anneal. it is tough to move that much body at 6mm in one step [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6mm HLS case formimg help
Top