Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.8 SPC 110v-max and bthp powders
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Codyg510" data-source="post: 864122" data-attributes="member: 49514"><p>IMR 8208 XBR</p><p></p><p>cheaper than varget (usually by about 5$ around here)</p><p>Accurate</p><p>Temp stable</p><p>Good velocity in short barrels 16-18"</p><p>extremely low velocity standard devation and extreme spread in my 16". Helps that it gives you full case capacity without going over maximum pressure. My loads were slightly compressed at 29.5g. 30 is listed as the max, but this powder is notoriously run over the max without pressure signs.</p></blockquote><p></p>
[QUOTE="Codyg510, post: 864122, member: 49514"] IMR 8208 XBR cheaper than varget (usually by about 5$ around here) Accurate Temp stable Good velocity in short barrels 16-18" extremely low velocity standard devation and extreme spread in my 16". Helps that it gives you full case capacity without going over maximum pressure. My loads were slightly compressed at 29.5g. 30 is listed as the max, but this powder is notoriously run over the max without pressure signs. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.8 SPC 110v-max and bthp powders
Top