Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.5-06 Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="MudRunner2005" data-source="post: 1387694" data-attributes="member: 12995"><p>When I form .270 Win into pre-prepped .25-06 AI brass, I remove the sizing ball and stem from the FL die, and then trim them .020" too long and chamfer and deburr the case neck, then I put the expander ball back in the FL die, and then run them through again to make sure they are fine and then measure again to ensure they're the proper length of being .020" too long.</p></blockquote><p></p>
[QUOTE="MudRunner2005, post: 1387694, member: 12995"] When I form .270 Win into pre-prepped .25-06 AI brass, I remove the sizing ball and stem from the FL die, and then trim them .020" too long and chamfer and deburr the case neck, then I put the expander ball back in the FL die, and then run them through again to make sure they are fine and then measure again to ensure they're the proper length of being .020" too long. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.5-06 Question
Top