Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 edge brass ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Shawn Carlock" data-source="post: 264211" data-attributes="member: 4"><p>Dave,</p><p> </p><p> I too figured the same before I tried it. It turns out that after sizing down the 375 the neck wall thickness is only .001-.0015" thicker than the 300 rum brass necked out (odd). I have used it with out turning and gotton good results. If you use a neck bushing die to size with it is easier to buy a 338 RUM FL sizing die from RCBS to do the initial neck out than to use the bushing die.</p></blockquote><p></p>
[QUOTE="Shawn Carlock, post: 264211, member: 4"] Dave, I too figured the same before I tried it. It turns out that after sizing down the 375 the neck wall thickness is only .001-.0015" thicker than the 300 rum brass necked out (odd). I have used it with out turning and gotton good results. If you use a neck bushing die to size with it is easier to buy a 338 RUM FL sizing die from RCBS to do the initial neck out than to use the bushing die. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 edge brass ?
Top