Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 RUM load development questions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Tidesloe" data-source="post: 747210" data-attributes="member: 47761"><p>I'm using Redding competition bushing neck die, Redding body die if FL sizing is needed. This is a new die set for me. I checked all the case necks for concentricity before loading and they showed no neck runout. The runout was in the bullet after seating with Redding competition seater. I'm starting the seating rotating 90 degrees seat a little more rotate 1/4 seat a little more and then another 90 degree rotation before complete seating. I'm seating Accubonds with no runout using this method</p><p>Its only with VLD's that the runout becomes an issue.</p><p>If I'm understanding correctly, I am using bushing dies so I can bush it down to correct diameter without using the expander</p><p>That nosler brass I never even ran through a neck sizer before loading, but will bushing neck size for next loading</p></blockquote><p></p>
[QUOTE="Tidesloe, post: 747210, member: 47761"] I'm using Redding competition bushing neck die, Redding body die if FL sizing is needed. This is a new die set for me. I checked all the case necks for concentricity before loading and they showed no neck runout. The runout was in the bullet after seating with Redding competition seater. I'm starting the seating rotating 90 degrees seat a little more rotate 1/4 seat a little more and then another 90 degree rotation before complete seating. I'm seating Accubonds with no runout using this method Its only with VLD's that the runout becomes an issue. If I'm understanding correctly, I am using bushing dies so I can bush it down to correct diameter without using the expander That nosler brass I never even ran through a neck sizer before loading, but will bushing neck size for next loading [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 RUM load development questions
Top