Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 prc brass stuck in bushing die
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="onetohunt" data-source="post: 2421303" data-attributes="member: 99834"><p>Kinda of crazy. I have a set of new Redding 300 PRC dies that I can't get the casing to go into but about 1/2 the case. I cleaned the new die and lubed the case with imperial wax and it went about 1/2 way. This was a once fired case. I then took the decapping pin out and lubed it up again and it would only go about 1/2 again. The once fired case was a Hornady case. I then went a got a new piece of Lapua brass and it went in about 3/4 of the way with the decapping pin out. It has me puzzled as well.</p></blockquote><p></p>
[QUOTE="onetohunt, post: 2421303, member: 99834"] Kinda of crazy. I have a set of new Redding 300 PRC dies that I can't get the casing to go into but about 1/2 the case. I cleaned the new die and lubed the case with imperial wax and it went about 1/2 way. This was a once fired case. I then took the decapping pin out and lubed it up again and it would only go about 1/2 again. The once fired case was a Hornady case. I then went a got a new piece of Lapua brass and it went in about 3/4 of the way with the decapping pin out. It has me puzzled as well. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 prc brass stuck in bushing die
Top