Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 prc brass stuck in bushing die
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Stonyman88" data-source="post: 2419446" data-attributes="member: 121659"><p>OK, hate this when it happens, but here's a little trick, number one, get a good pairs of vice grips , other option is a easy out that you can run into the flash hole, then grab it with the grips, or in a vice, just get a good grip before you start, get a hammer ready, and torch, heat the outside of the die , remove the top if you can, the primer pin piece, this must be done quickly, heat the outside of the die for about 20 seconds all around the die, now tap the vice grips and that boy should pop right out, and it won't hurt the die to heat it a little, you just want the die to swell up a .001 or so. Something must have gotten intothe die, always clean them with a good cleaner every time you use them. I have seen some with a heavy type oil or cosmolin , and if it drys out,,,look out, Let me know if you get it out. Mail it to me and I'll fix it if possible.</p></blockquote><p></p>
[QUOTE="Stonyman88, post: 2419446, member: 121659"] OK, hate this when it happens, but here's a little trick, number one, get a good pairs of vice grips , other option is a easy out that you can run into the flash hole, then grab it with the grips, or in a vice, just get a good grip before you start, get a hammer ready, and torch, heat the outside of the die , remove the top if you can, the primer pin piece, this must be done quickly, heat the outside of the die for about 20 seconds all around the die, now tap the vice grips and that boy should pop right out, and it won't hurt the die to heat it a little, you just want the die to swell up a .001 or so. Something must have gotten intothe die, always clean them with a good cleaner every time you use them. I have seen some with a heavy type oil or cosmolin , and if it drys out,,,look out, Let me know if you get it out. Mail it to me and I'll fix it if possible. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
300 prc brass stuck in bushing die
Top