Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
30 Nosler vs 300WM vs 300PRC
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="CA48" data-source="post: 2361070" data-attributes="member: 21446"><p>To the OP with your needs your good go with any of those. Of course 300 win Mag is the most established but I would not build one of the other two just because it's hard to find components. If your patient and look around you can find brass may take a month or 2 but it can be done. Any of them will get the job done. Out of those you listed I would go 30nos. ADG brass is available right now. It will give the best velocity and fits in a L/A well.</p><p></p><p>I myself went with a 20" 30 Sherman Mag pushing 215s at 2950 fps with n570. Some think that's to hot but when I'm getting double digit brass life and am 2+ grains away from any sign of bolt lift I tend to ignore them. All my Sherman cartridges have done what Rich said they would and his customer service has been excellent. But I go into a build knowing I may not be able to run the highest velocity Rich tested. Brass has been the weak link and with adg or lapua where you can run 70k+ and still get 2-3 firings before pockets loosen up ( not that I run there) I don't think running just over 60k is unsafe on a Mag bolt face. I beleive a lot of that thinking comes from the past when norma was the best brass available. Sammi max is 65k psi.</p></blockquote><p></p>
[QUOTE="CA48, post: 2361070, member: 21446"] To the OP with your needs your good go with any of those. Of course 300 win Mag is the most established but I would not build one of the other two just because it’s hard to find components. If your patient and look around you can find brass may take a month or 2 but it can be done. Any of them will get the job done. Out of those you listed I would go 30nos. ADG brass is available right now. It will give the best velocity and fits in a L/A well. I myself went with a 20” 30 Sherman Mag pushing 215s at 2950 fps with n570. Some think that’s to hot but when I’m getting double digit brass life and am 2+ grains away from any sign of bolt lift I tend to ignore them. All my Sherman cartridges have done what Rich said they would and his customer service has been excellent. But I go into a build knowing I may not be able to run the highest velocity Rich tested. Brass has been the weak link and with adg or lapua where you can run 70k+ and still get 2-3 firings before pockets loosen up ( not that I run there) I don’t think running just over 60k is unsafe on a Mag bolt face. I beleive a lot of that thinking comes from the past when norma was the best brass available. Sammi max is 65k psi. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
30 Nosler vs 300WM vs 300PRC
Top