Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
270 wsm reload question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="dale1386" data-source="post: 1513247" data-attributes="member: 83589"><p>Finally got my Savage 10 270 wsm project finished and loaded up 10 rounds of ammo to sight in scope and I had all kinds of problems and I'm asking for input on what went wrong.</p><p>First my load recipe......case trimmed to spec. I loaded 53.0 grains of IMR 4064 with Remington 130 grain Core lokt bullet. My COL is 2.825" CCI 250 magnum primer.</p><p></p><p>Now for the problem. All 10 rounds chambered ok but after shooting I couldn't hardly pull the bolt back on every round and actually had to tap on the bolt handle with a block of wood on one round and also 2 of the 10 blew out the primer. After some research I read possible cause could have been excessive head space causing pressure increase. does that sound correct? I don't know what my rifle lands or but my COL seems reasonable from what I've read.....not much data on Remington Core Lokt's 130 grain for 270 WSM. I'm not loading any more till I figure out the problem.</p></blockquote><p></p>
[QUOTE="dale1386, post: 1513247, member: 83589"] Finally got my Savage 10 270 wsm project finished and loaded up 10 rounds of ammo to sight in scope and I had all kinds of problems and I'm asking for input on what went wrong. First my load recipe......case trimmed to spec. I loaded 53.0 grains of IMR 4064 with Remington 130 grain Core lokt bullet. My COL is 2.825" CCI 250 magnum primer. Now for the problem. All 10 rounds chambered ok but after shooting I couldn't hardly pull the bolt back on every round and actually had to tap on the bolt handle with a block of wood on one round and also 2 of the 10 blew out the primer. After some research I read possible cause could have been excessive head space causing pressure increase. does that sound correct? I don't know what my rifle lands or but my COL seems reasonable from what I've read.....not much data on Remington Core Lokt's 130 grain for 270 WSM. I'm not loading any more till I figure out the problem. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
270 wsm reload question
Top