Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
168 GR ABLR seating depth for 7MM RM
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="deweyduck" data-source="post: 1995901" data-attributes="member: 69421"><p>After lots of comments about these bullets, I am interested in trying some and I tried reseating factory loads to .010 jump. That decreased the group to 2 inches but way too wide compared to my handloaded168 VLD's at zero jump which nets a typical 3/4" 100 yard group. My gun is an off the shelf Win 70 with 9.25" twist. Factory jump is really deep and not accurate enough at all. So, I'm looking for a tip so as to avoid wasting $$ seeking a tighter group. My zero range is 300 yards and my expected targets will be 200-400. Any help will be greatly appreciated.</p></blockquote><p></p>
[QUOTE="deweyduck, post: 1995901, member: 69421"] After lots of comments about these bullets, I am interested in trying some and I tried reseating factory loads to .010 jump. That decreased the group to 2 inches but way too wide compared to my handloaded168 VLD's at zero jump which nets a typical 3/4" 100 yard group. My gun is an off the shelf Win 70 with 9.25" twist. Factory jump is really deep and not accurate enough at all. So, I'm looking for a tip so as to avoid wasting $$ seeking a tighter group. My zero range is 300 yards and my expected targets will be 200-400. Any help will be greatly appreciated. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
168 GR ABLR seating depth for 7MM RM
Top