Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Long Range Hunting & Shooting
$100K 1/2 MOA rifle?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="del2les" data-source="post: 2794357" data-attributes="member: 9299"><p>A <strong>Hunter Class rifle</strong> is described in the NBRSA rule book but the basics are as follows: A Hunter rifle stock must not be over 2 ¼ inches wide and be convex on all bottom surfaces of the stock. Bolt action receivers must be no wider than 1.400 inches and no longer than 10.25 inches. Custom re-barreling is permitted. The barrel shall have a diameter of not more than 1.250 for 4 inches in front of the bolt face and would taper to a diameter of .750 diameter at 26 inches from the bolt face. Original factory issue barrels need not meet these specifications. Glue-ins are not allowed. Bore diameter can be up to .338 and case capacity is not limited. Magazines shall not be required, but receivers must be cut out for a magazine. Scopes must be 6X or less. Variables are allowed but must be set at 6X and taped. Rifle and scope not to exceed 10 pounds in weight. Falling Block/Rolling Block single shot rifles will be allowed in Hunter Class competition.</p></blockquote><p></p>
[QUOTE="del2les, post: 2794357, member: 9299"] A [B]Hunter Class rifle[/B] is described in the NBRSA rule book but the basics are as follows: A Hunter rifle stock must not be over 2 ¼ inches wide and be convex on all bottom surfaces of the stock. Bolt action receivers must be no wider than 1.400 inches and no longer than 10.25 inches. Custom re-barreling is permitted. The barrel shall have a diameter of not more than 1.250 for 4 inches in front of the bolt face and would taper to a diameter of .750 diameter at 26 inches from the bolt face. Original factory issue barrels need not meet these specifications. Glue-ins are not allowed. Bore diameter can be up to .338 and case capacity is not limited. Magazines shall not be required, but receivers must be cut out for a magazine. Scopes must be 6X or less. Variables are allowed but must be set at 6X and taped. Rifle and scope not to exceed 10 pounds in weight. Falling Block/Rolling Block single shot rifles will be allowed in Hunter Class competition. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Long Range Hunting & Shooting
$100K 1/2 MOA rifle?
Top