Recent content by valin

The best loads seem to be at 114.0 gr. of the Reloader 25 on the Barnes 225 ttsx's. I played around with length of 3.740", and 3.763", and they grouped very similarly, but they move more easily through my magazine at 3.740", so I will stay there. Groups are just under an honest 3" (outside of...

I will be able to do that after this upcoming weekend. I did not have a chronograph with me when I was shooting last time, so current velocities are unknown. I have also not loaded any higher than the 114's, but I will be testing heavier loads, and I have not reached the point of compressed loads.

Thanks.

Well, since nobody seems to be running 225's in this rifle setup, I figured I would post a bit of progress for others to see for future use. I am now running Alliant Reloader 25 powder, and Barnes 225 gr. TTSX bullets, and things are starting to come together. I loaded 24 shells, and headed...

I am about to try out loading some TTSX 225's on some Reloader 25 powder, and am wondering if anyone had any load data for me. I sure would appreciate the help, since I've been having some difficulty trying to get some decent accuracy out of this thing. Rifle: Weatherby Accumark 338-378 28"...

I am about to try running some 250gr. Speer Grand Slam bullets for my 338-378, and am wondering if any of you have any load data for the 250's with h1000 powder, or have a recommendation of where I should start. Thanks.

I was unable to get the TTSX's, so I picked up some 250gr. Speer Grand slams instead, since most of you guys recommend 250-300gr. I also picked up some H1000 powder, and am going to do some loading this weekend. Any recommend loads?

Thanks for the input guys. I will pick up some H1000, and play with that with the 225 TTSX's. On the Nosler site, they recommend the low at 107 gr. and the max of 111 gr. with a 225gr bullet. Have any of you guys played with 225 TTSX's?, and what loads did you end up with for accuracy? How...

This is a load that I had found in the nosler loading manual, and I have also seen it posted online previously. It is the first load that I was attemping to run, since this rifle is new to me.

I really do appreciate the input guys. I went back out shooting today, with a buddy of mine who runs the same rifle. I swapped out scopes, and ended up with the same result......still all over the place. We then fired my loads in his 338-378 and ended up with the same results, so therefore...

Hey guys. I've been having a difficult time trying to figure out why I am getting such terrible grouping with my Weatherby Accumark 338-378. At 100 yards, the accuracy is all over the place, and i'm talking 8" at times. The scope I am running is a Leupold VX-3L 4.5-14x50. I am shooting from...

This is going to be used for target and various hunting conditions, with distances possible from 50 yds to roughly 700 yds. I will not be shooting further than that.

No coin slot on my scopes. I sent Leupold an email regarding my questions. I might just go that route, if I can get around customs.

Is there anywhere I can purchase the proper turret and install it myself? It isn't easy for me to ship optics from Canada to the US.

Guys, I run a Weatherby Accumark 338-378, with a Leupold VX-3L 4.5-14x50mm scope, and I would like to know if I am able to purchase and install turrets for this scope? If so, where can I get them? Thanks for the help.